wipping isatopes to a rod

[pookie]

Can anyone tell me how and what to use to wip a isatoe tip light to the rod.

also any website showing you how.

[Ronald]

how's it going pooks ,i use clear silicone tubing ,slide over the light and leave about 10 mm either end spare to whip onto the rod tip then coat whipping with clear whipping varnish to stop it unravaling over time .

[pookie]

not bad mate have not seen you post in a bit try make next met.

iam wondering what side of the rod do i wip it to the ring side or other(multiplier rod) also what wipping do you use (name product)

[BigPhil]

whatever you do dont put it on the same side as the rings! and keep it down a bit from the very tip of the rod, to help prevent the line gettin caught on it during the cast. a few wraps with any kind of thread and then a few coats of a clear nail varnish will hold these in place if you are not that particular about how it looks!(hard as nails)is a good varnish for the job
good luck