OK, I got an Abu 6500c recently, the classic model I think, no mag brakes or anything fancy. It was levelwind, so I got a conversion kit and fitted that, but when I put the reel back together the spool seems to move a lot more (lateral movement, from one sideplate to the other)
Have I done something wrong or is this a bad thing? Or am I imagining that it moves more now???
Abu 6500C levelwind conversion
Moderators: Seaniebo, corbyeire
-
Bradan
- SAI Megalodon!
- Posts: 1077
- Joined: Thu Sep 15, 2005 5:32 pm
- Location: On a beach/lake/river somewhere..
Abu 6500C levelwind conversion
Its called fishing, not catching. If it was called catching it wouldn't be fishing!
http://www.flickr.com/photos/bradan99
http://www.flickr.com/photos/bradan99
-
Marty Harrison
- SAI Hammerhead
- Posts: 308
- Joined: Mon Jan 12, 2004 3:51 pm
- Location: Co.Down
If you removed the cog from the spool that drives the level wind during the conversion that will be causing the problem. It needs to be there to take up the space from the spool side to the bush the spindle sits in. A spacer is avail as an extra for tournament conversions but if its for fishing you shouldnt need to worry just put it back in. This is presuming its an ultracast model were the spool houses the bearings and sits on spindle.
If its not the above check the end float cap/caps and make sure they are screwed down so as to center the spool in the cage and give the slightest wee bit of end float when you move the spool side to side.
Marty
If its not the above check the end float cap/caps and make sure they are screwed down so as to center the spool in the cage and give the slightest wee bit of end float when you move the spool side to side.
Marty
SACN Membership #0702