eye repair

Message

#1 Post by **croppyboy** » Mon Jan 29, 2007 10:54 am

Hi Lads

in a bit of bother i have entered the comp thats in courtown on sunday but have noticed that my top eye on my leada rod is fraying the line anyone know anybody who can fix it in a hurry

i have tried a few tackle shops and they are saying it will take 2 weeks

thanks

croppy

#2 Post by **frodo baggins** » Mon Jan 29, 2007 12:00 pm

do it yourself. it's pretty easy. pick up a new ring in the shop (check the diameter to make sure) then carefully strip the whipping off the damaged eye with a sharp knife, take your time, the whipping will unwrap easy enough. remove all the thread, now get a lighter and hold under the damaged ring to melt the adhesive binding the ring to the rod, after a few seconds the ring should slide off easy enough. remove any old adhesive with some fine sand paper.
now the new ring, adda few drops of glue (just any decent shop bought glue) i can't think of any names off the top of my head but a good general purpose one will be fine. nothin special. hold the ring in place and make sure the ring is aligned with all the other rings!!!! that will get you through one session no problem. you can try whipping on some new thread if you like, it's not that hard. and add a drop of glue over the whipping to hold it firm.

i can't get over that none of your tackle shop will do it, it only takes 10 minutes if you nkow what you're doing. it's really easy though.

Good luck

Patrick

#3 Post by **m.b3** » Mon Jan 29, 2007 2:21 pm

agreed. should only take 2 minutes!

#4 Post by **Donagh** » Mon Jan 29, 2007 2:34 pm

I'd advise to use hot melt glue if you can. Makes it easier to take the tip ring off if it gets damaged again. Don't use allow araldite as some tackle shops do for this reason.

Donagh

Rockhopper · #5 Post by **Rockhopper** » Mon Jan 29, 2007 4:21 pm

Croppy......BIG WARNING!!!! if you do decide to do the job yourself...like has been said...place a flame under the tip to soften the glue...BUT!! as you pull the tip off....DO NOT SCREW the tip right and left....pull it off in a straight line to the blank tip.

The reason for this is.....your at the thinest part of the rod blank...the heat can also effect the resin in the blank and if you twist it the fibres in the tip can end up like a paint brush....this would mean cutting the blank back....after saying that....dont be afraid to go for it and do it yourself...like others have said...its not rocket science.

Hope this helps you.. :)

Tom.

#6 Post by **croppyboy** » Mon Jan 29, 2007 4:36 pm

Thanks a lot lads ill give it a try

#7 Post by **alannelson** » Mon Jan 29, 2007 5:55 pm

If i notice one of my rings has a slight crack on the beach i put some of my girlfriends clear nail varnish over the crack just to smooth iit over just for that session untill you can get the ring replaced :lol:

Sea Angling Ireland

eye repair

eye repair

eye repair

Re: eye repair